Product Support
GOgroove Phono Preamp EQ with 3 Band Equalizer
Product Name:
Phono Preamp EQ with 3 Band Equalizer - RIAA Equalization , RCA Input / Output - Black Preamp EQModel Number:
GGAAPPQ100BKUS
Frequently Asked Questions
Connecting the Phono Preamp EQ
Power:
Operating Instructions
Operating Instructions
Connect the AC adapter to the DC 12V input
Connect the ground wire from the turn table to the GND screw
Press the power button to turn on. The power indicator will be lit.
Input:
RCA: Connect your turntable to the RCA IN ports L and R
NOTE: The signal indicator will be lit when receiving audio
DIN: Connect DIN cable to the DIN IN port
NOTE: The signal indicator will be lit when receiving audio
Output:
The preamp can be connected to amplifiers, mixers, and recording units. Do not use the RCA and DIN outputs simultaneously
RCA: Connect RCA cable to RCA OUT ports L & R DIN: Connect DIN cable to the DIN OUT port
Controls of the Phono Preamp EQ
Controls:
Features of the Phono Preamp EQ
Amplifier and an Equalizer
Phono Preamp EQ Specifications
Product Specifications:
What are the dimensions of the Phono Preamp EQ?
Dimensions:
Phono Preamp EQ producing static/distortion
In order for the Phono Preamp EQ to be compatible with your setup, your turntable must have a connected grounding wire. Turntables will NOT function properly w/o a grounding wire connected to the Preamp. The Preamp can be connected to amplifiers, mixers and recording units.The RCA and DIN outputs cannot be used simultaneously.
Troubleshooting
- Make sure that the turntable does not already have a built-in preamp in the turntable
- You would know if you did if your receiver or amp has an input labeled PHONO
- Ensure that the needle to the turntable is not damaged as this can cause the lacking in bass
- Check for visible damage such as jagged edges or bending of the needle head.
- You may also need to adjust the counterweight on the needle to better the audio.
- In order to do this, reference the manufacturer's guide to safely follow the procedure and not damage the needle in the process.
- Check to make sure the GND wire is tightly wound around the GND screw
- If you have a turntable with no GND wire, then it will not be compatible with the Preamp EQ
- Contact your turntable’s manufacturer to see if a GND wire could be connected
- Try adjusting the INPUT GAIN and MONITOR LEVEL knobs until the static/distortion is fixed
- Does this resolve the issue?
- Note that if the Clip Indicator light is blinking rapidly, you will need to turn DOWN the Input Gain level to avoid distortion
- Ensure that all cables are functioning properly
- Try using a different power source as the outlet may be outputting incorrectly
- Does plugging in a new power source resolve the issue?
Please contact Customer Support at support@accessorypower.com if the above troubleshooting does not resolve your issue
How are the EQ knobs suppose to feel?
The PCB is located far in the bottom of the unit with a long stem.
The longer the stem, the more "wiggle" there is. However, the ends come through holes that also supports the stem. So while the top knobs bay not be as tight as the front ones, they're still firm.
The longer the stem, the more "wiggle" there is. However, the ends come through holes that also supports the stem. So while the top knobs bay not be as tight as the front ones, they're still firm.
Product Videos
DOWNLOADS
Use the link(s) below to download software and manuals for your selected product.
Still Need Help?
If you've exhausted the above resources and haven't found what you are looking for, we've got you covered. Please login and register your product to get further support from our Customer Solutions department.